lap joint

英 [læp dʒɔɪnt]

美 [læp dʒɔɪnt]

（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝

计算机化学

英英释义

noun

• joint made by overlapping two ends and joining them together
  Synonym:splice

双语例句

• The elasto-plastic finite element method ( FEM) was used to investigate the effect of the elastic modulus of adhesive on the stress and strain distribution in adhesively bonded aluminium single lap joint.
  利用弹塑性有限元法研究胶粘剂的弹性模量对单搭接接头应力应变分布的影响。
• Stress Analyses of Double Lap Joint by Boundary Element Method
  双搭接接头应力场的边界元分析
• Using boundary element method, the interfacial streeses of adhensive lap joint with either perfect or imperfect interface are studied.
  采用边界元法计算分析了具有理想界面和非理想界面的双板条胶合搭接连接的界面应力。
• Temperature and Thermal Stress Distribution in Single Lap Joint
  单搭接接头温度场与热应力分布的研究
• The BEM technique for adhesive-bonded structure proves valid by comparing the stress distribution for double lap joint calculated in this paper with that calculated by finite element method.
  对双搭接接头进行了边界元应力分析，并和有限元结果进行了对比，从而证实本文方法的有效性。
• The results indicate that good lap joint between aluminum and galvanized steel sheet can be made in appropriate parameters.
  试验结果表明，铝和镀锌钢能得到成形良好的搭接接头。
• The orthogonal test of numerical modeling on the peck stress distributed in single lap joint
  单搭接接头峰值应力数值模拟的正交法分析
• However, further increasing of RE content would degrade the shear properties of the lap joint.
  而当稀土含量进一步增加时，焊点的强度及塑性均下降。
• Influence of Elastic Modulus of Adhesive on the Stress and Strain Distribution in Aluminium Single Lap Joint
  胶粘剂弹性模量对铝合金单搭接接头应力应变分布的影响
• The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.
  搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。